Precautions for the use of electric hospital beds
Electric hospital beds may be a new product for medical beds. As a new type of medical auxiliary equipment in modern hospitals, people will pay more attention to it. Because of the relatively simple, all-electric intelligent mode, electric beds make patients more comfortable, but also can achieve intelligent and accurate position conversion, reducing the labor intensity of nurses. If the lifting switch of the lifting mechanism is remotely controlled, self-care of the patient can also be achieved.
The working principle of the electric hospital bed: After the drive motor in the electric push rod is decelerated by the gear, it drives a pair of nuts to convert the rotation of the motor into linear motion, and uses the forward and reverse rotation of the motor to complete the push rod action. The push rod realizes different actions of the electric hospital bed through different levers, rockers and other mechanisms.
Pay attention to the use of electrical infirmary:
1. Before using the multifunctional electric infirmary, first check whether the power cord is firmly connected. Whether the controller cable is reliable. Guangxi Medical Devices
2. The wires and streamlined lines of the linear controller driver must not be placed between the rising joint and the upper and lower bed frames to prevent the wires from being cut and causing personal and equipment accidents.
3. After lifting the back plate, the patient stands upside down on the panel and should not push the back plate.
4. You should not jump on the bed; when the back board is lifted, people will sit on the back board and stand on the bed board instead of pushing.
5. After the universal wheel is braked, it does not push or move. It can only move after releasing the brake.
6. Do not push horizontally to avoid damage to the handrail.
7. The road is uneven, do not push, so as not to damage the universal wheel of the multifunctional electric medical bed.
8. When using the controller, you can only press the control panel buttons one by one. The multi-function electric medical bed does not press more than two buttons to avoid accidents that may endanger the patient.
9. When it is necessary to move the multifunctional electric hospital bed, disconnect the plug and wind the power controller wire to push it. Guangxi Medical Supplies
10. When it is necessary to move the multifunctional electric bed, the handrail should be raised to prevent the patient from falling and injuring during the movement. When moving the electric bed, two people are required to work at the same time to avoid losing direction control during the implementation process, causing damage to structural components and endangering the health of patients.
The above content is collected and sorted by the Internet, and the copyright belongs to the original creator. If there is any infringement, please contact us to handle the deleted content, thank you!
More news
Address: Building 12, Changgui ASEAN Science Park, 146 Wuhua Avenue, Guangxi ASEAN Technology Development Zone
Nanning Office: 4th Floor, Block C, Yongjia Building, Xinmin Road, Qingxiu District, Nanning City